JoytoKey configuration

This article is to show you how to locate, use, and configure your ANKI remote using the JoytoKey software.

1. Go to Start menu and type "Joy" it should pull up the application and you will select open as shown below:
   
   
2. Now that the application has opened you will take your paired and connected ANKI controller and select a button. When you press that button it will highlight in yellow which button it relates to in JoytoKey. Once you have found the highlighted button you will double-click to configure it for use.
   
   
3. You will then select the corresponding command for the button you have selected in the top left dialog box and it will automatically assign that function to the button and from there you will select "OK".
   
   
    
   1. ***Special note*** If you are setting up a function that is a combination of two different commands/functions such as Ctrl+Z (Undo), you will need to enter each part in a different dialog box in the top left when configuring the button as shown below:
      
      
4. This is what it looks like when your buttons have properly been configured and assigned functions:
   
   

This article should be used in conjunction with the following article for how to configure your ANKI controller: https://fsumed.teamdynamix.com/TDClient/2884/Portal/KB/ArticleDet?ID=167439

If you have any questions, please reach out to the Service Desk.